• OmniLop framifrån
  • CGM Arm Holder – Produktbild
  • Svart CGM arm holder produktbild
1 3

OmniLoop – Justerbart Armband för Omnipod utan Plåster

OmniLoop – Justerbart Armband för Omnipod utan Plåster

349 SEK
349 SEK
Sale Sold out
Tax included. Shipping calculated at checkout.

Diabeteshjalp

Färg

OmniLoop – Håll din Omnipod säker utan plåster eller overpatches

OmniLoop är ett handgjort armband med plastskydd speciellt utformat för Omnipod. Det håller din pod på plats och förhindrar att den lossnar i förtid – helt utan behov av klisterplåster eller overpatches. Perfekt för dig som är aktiv och vill ha extra trygghet att din Omnipod sitter kvar under hela dagen.

Om produkten – OmniLoop Armband

OmniLoop är ett lätt och diskret armband med ett handgjort plastskydd som omsluter din Omnipod och håller den stadigt på plats. Det justerbara bandet med spänne gör det enkelt att anpassa passformen för olika armomfång. Till skillnad från overpatches och klistermärken är OmniLoop återanvändbart och lämnar inga limrester på huden.

Specifikationer

  • Kompatibilitet: Omnipod DASH och Omnipod 5.
  • Skydd: Handgjort plastskydd för Omnipod.
  • Armbandsbredd: 2,5 cm.
  • Armbandslängd: 43 cm – passar de flesta armomfång.
  • Fäste: Justerbart med spänne (buckle).
  • Design: Lätt och diskret.
  • Återanvändbart: Kan användas om och om igen.

Fördelar

  • Inga plåster behövs: Håller Omnipod på plats utan klistermärken eller overpatches.
  • Handgjort skydd: Plastskyddet omsluter podden och ger extra stabilitet.
  • Justerbart band: Spännet gör det enkelt att anpassa för olika armomfång.
  • Lätt och diskret: Känns knappt och syns minimalt under kläderna.
  • Återanvändbart: Miljövänligare alternativ till engångspatchar.

Perfekt för

  • Aktiva Omnipod-användare som vill ha extra trygghet under träning och lek.
  • Dig som har känslig hud och vill undvika tejp och lim.
  • Barn och vuxna som vill bära sin Omnipod säkert och diskret.

Observera: Omnipod-enheten ingår ej i förpackningen.

CGM Patch Instructions for Use

Instructions for use - CGM Patches

Product description

CGM patches are designed to provide additional fixation to a patch or tape when using continuous glucose monitors (CGM) and infusion sets. They are made of skin-friendly and breathable material on the skin during daily activities.
CGM patches are designed to provide additional fixation stability when using continuous glucose monitors (CGM) and infusion sets. They help keep the sensor or infusion set in place during daily activities, including physical exercise and bathing.

Area of application

  • Intended for use with CGM devices and infusion sets.
  • Made of skin-friendly and breathable material.
  • Can be used for up to 12 days depending on skin type and activity level.

User manual

Before application

  1. Wash and dry the skin thoroughly in the area where the patch will be applied.
  2. Make sure the skin is free of oils, creams or lotions that may affect adhesion.
  3. The area should be free of hair to ensure the best possible adhesion.
  4. If you have sensitive skin, a skin barrier spray can be applied for extra protection.
  5. Wash and dry the skin thoroughly in the area where the patch will be applied.
  6. Make sure the skin is free of oils, creams or lotions that may affect adhesion.
  7. If you have sensitive skin, a skin barrier spray can be applied for extra protection.

Application

  1. Carefully remove the protective film from one side of the patch.
  2. Center the patch over the CGM sensor or infusion set and gently press it against the skin.
  3. Remove the remaining protective film and smooth the patch so that it adheres evenly without creases or air bubbles.
  4. Press lightly over the entire surface for a few seconds to ensure good adhesion.

During use

  • The patch is designed to be water-resistant and can be used in showers and light bathing.
  • Avoid rubbing or tearing the patch to extend its durability.
  • If necessary, the edges can be gently pressed back in if they start to come loose.

Removal

  1. Gently pull one edge of the patch and slowly peel it off parallel to the skin to minimize irritation.
  2. If the patch is stuck tightly, you can use an oil-based remover or warm water to loosen the adhesion.
  3. Wash the area with mild soap and water after removal.

Storage & Durability

  • Store the patches in a dry and cool environment.
  • Avoid direct sunlight and extreme temperatures.
  • The product is intended for single use and should not be reused.

Safety information

  • For external use only.
  • Discontinue use if irritation or skin reaction occurs and consult a doctor if necessary.
  • The patch is not a replacement for the adhesive feature included with the CGM or infusion set.
  • Keep out of reach of small children to avoid accidental use. The product can be used by both children and adults under the supervision of a guardian or healthcare professional if necessary.
  • Our designs are printed over a larger pattern sheet, which means that each patch is unique. There may therefore be variations in the placement of the pattern compared to the product images on the website.

Certification & Compliance

Diabeta Solutions Sweden AB is a distributor of this product and not the manufacturer. The product is manufactured by a CE certified manufacturer who is responsible for the product's compliance with applicable legal requirements and certification according to MDR (EU) 2017/745. Diabeta Solutions Sweden AB is only responsible for distribution and customer support.

CE marked according to MDR (EU) 2017/745 – Certification carried out by the manufacturer
Manufactured for Diabeta Solutions Sweden AB by a CE-certified manufacturer

View full details